我把蜂鸟E203的软核输出给了外部的IO口然后连接了非官方的jtag调试器。在用jlink连接时报错：
The connected J-Link does not support selecting another hart/core than 0 for RISC-V

报错全部信息如下：
Connecting …

• Connecting via USB to probe/ programmer device 0
• Probe/ Programmer firmware: J-Link V11 compiled Nov 12 2020 10:07:08
• Device “RV64” selected.
• Target interface speed: 4000 kHz (Fixed)
• VTarget = 3.285V
• ConfigTargetSettings() start
• ConfigTargetSettings() end
• TotalIRLen = 5, IRPrint = 0x01
• JTAG chain detection found 1 devices:
• Id: 0x1E200A6D, IRLen: 05, Unknown device
• Debug architecture:
• RISC-V debug: 0.11
• AddrBits: 5
• DataBits: 34
• IdleClks: 5
• ISA: RV32I+
• ERROR: The connected J-Link does not support selecting another hart/core than 0 for RISC-V
  Specific core setup failed.
• ERROR: Failed to connect.
  Could not establish a connection to target.

另外，想问下在用nuclei studio调试的时候，在debug configuration里该怎么填写device name？

在jflash里面找不到合适的选项，选择RISCV或者RV32/RV64都会报上面的错误